Pinouts of Connectors

Apple IIc Joystick Connector pinout

layout
schematic diagram

add this page to bookmarks

UNKNOWN connector  at the Apple computer
Pin Name Description
1 GAMESW1 Switch input 1 (sometimes called paddle button 1).
2 +5V +5 VDC (max 100mA)
3 GND System ground.
4 n/a Not used
5 PDL0 Paddle 0 hand controller input. Must be connected to a 150K ohm variable resistor connected to +5V.
6 n/c Not connected
7 GAMESW0 Switch input 0 (sometimes called paddle button 0).
8 PDL1 Paddle 1 hand controller input; must be connected to a 150K ohm variable resistor connected to +5V.
9 n/a Not used

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of input devices (keyboards, mices, joysticks) >  Pinout of Apple IIc Joystick Connector and layout of connector

Source(s): Apple Tech Info Library 1419: Apple IIc, External Pinouts at Apple TIL homepage
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
47 hits since February 12, 2005