Pinouts of Connectors

Memory stick connector pinout

layout
schematic diagram

add this page to bookmarks

10 pin Memory stick special connector pin-out & layout
10 pin Memory stick special connector  at the card
Memory Stick consists of a controller IC and NAND flash memory. Controller consists of serial-pararell/pararell-serial interface block, register to set various data, page buffer of 512 byte, ECC generator block, interface block for flash memory, etc.

Memory stick is read or written by half-duplex serial protocol of three-wire system.

Pin Signal Description
1VSS  
2BS IN, Serial protocol bus state signal
3VCC IN
4DIO IN/OUT, Serial protocol data signal
5Reserved  
6INS Stick insertion/extraction detect
7Reserved  
8SCLK IN, Serial protocol clock signal
9VCC  
10VSS  
Write speed is 1,800MB - 330KB/s. Depends on flash memory cell. Read speed is 2.45MB/s.
Power source voltage is 2.7 - 3.6V. Serial clock is 20MHz(MAX).

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different memory connectors >  Pinout of Memory stick connector and layout of 10 pin Memory stick special connector

Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
151 hits since February 12, 2005