Pinouts of Connectors

Defintion: DTE & DCE pinout

layout
schematic diagram

add this page to bookmarks

DTE

DTE is acronym for Data Terminal Equipment.

Examples of DTE is computers, printers & terminals.

DCE

DCE is acronym for Data Communication Equipment.

Examples of DCE is modems.

Wiring

Wiring a cable for DTE to DCE communication is easy. All wires goes straight from pin x to pin x.

But wiring a cable for DTE to DTE (nullmodem) or DCE to DCE requires that some wires are crossed. A signal should be wired from pin x to the opposite signal at the other end. With opposite signals I mean for example Transmit & Receive.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Different Information >  Pinout of Defintion: DTE & DCE and layout of connector

Source(s): Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
68 hits since February 11, 2005