Pinouts of Connectors

Media Independent Interface (MII) Connector pinout

layout
schematic diagram

add this page to bookmarks

40 pin HI-DENSITY D-SUB female connector pin-out & layout
40 pin HI-DENSITY D-SUB female connector  at the network device
Pin Name Dir Description
1 V --- +5 Vdc/ 3.3 Vdc
2 MDIO <-> MII Data Input/Output
3 MDC --> MII Data Clock
4 RxD <-- Rx Data
5 RxD <-- Rx Data
6 RxD <-- Rx Data
7 RxD <-- Rx Data
8 Rx_DV <-- Rx Data Valid
9 Rx_CLK <-- Rx Clock
10 Rx_ER <-- Rx Error
11 Tx_ER --> Tx Error
12 Tx_CLK <-- Tx Clock
13 Tx_EN --> Tx Enable
14 TxD --> Tx Data
15 TxD --> Tx Data
16 TxD --> Tx Data
17 TxD --> Tx Data
18 COL <-- Collision
19 CRS <-- Carrier Sense
20 V --- +5 Vdc/ +3.3 Vdc
21 V --- +5 Vdc/ +3.3 Vdc
22 GND --- Ground
23 GND --- Ground
24 GND --- Ground
25 GND --- Ground
26 GND --- Ground
27 GND --- Ground
28 GND --- Ground
29 GND --- Ground
30 GND --- Ground
31 GND --- Ground
32 GND --- Ground
33 GND --- Ground
34 GND --- Ground
35 GND --- Ground
36 GND --- Ground
37 GND --- Ground
38 GND --- Ground
39 GND --- Ground
40 V --- +5 Vdc/ +3.3 Vdc

Note: Direction is DTE (Network device) relative DCE (Transciever)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
40 pin HI-DENSITY D-SUB male connector pin-outs & layouts
40 pin HI-DENSITY D-SUB male connector  at the transciever
Pinouts.ru > Pinouts of local network connectors >  Pinout of Media Independent Interface (MII) Connector and layout of 40 pin HI-DENSITY D-SUB female connector and 40 pin HI-DENSITY D-SUB male connector

Source(s): Ethernet (IEEE802.3) page at Connectivity Knowledge Platform (Made IT)
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
123 hits since February 11, 2005