Pinouts of Connectors

Palm M125/130/500/505/515/i705 connector pinout

layout
schematic diagram

add this page to bookmarks

16 pin PALM special connector pin-out & layout
16 pin PALM special connector  at the PDA
Pin Signal Description
1GND Signal- and charge ground (connected to pin 7) 
2USB_D+ Positive USB data signal 
3USB_D- Negative USB data signal 
4VBUS VBUS signal 
5HOTSYNC HotSync IRQ - +3.3V for button push 
6N/C Not Connected 
7GND Signal- and charge GND (connected to pin 1) 
8ID Identification for peripherials 
9Vout +3.2V supply output, 100mA max. 
10RxD RS-232 RxD signal (input), GPS T 
11TxD RS-232 TxD signal (output), GPS R 
12DETECT peripherial detect - tied to ground by peripherials 
13CTS RS-232 CTS signal (input) 
14RTS RS-232 RTS signal (output) 
15DTR RS-232 DTR signal (output) 
16CHARGE +5V charge supply input, 500-700mA 

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > PDA, HandHeld computers connectors >  Pinout of Palm M125/130/500/505/515/i705 connector and layout of 16 pin PALM special connector

Source(s): kolumbus.fi, http://www.pspilot.de/pppm505/pppm505.html
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
120 hits since February 11, 2005