Pinouts of Connectors

Parallel (Amiga) connector pinout

layout
schematic diagram
add this page to bookmarks

25 pin D-SUB FEMALE connector pin-out & layout
25 pin D-SUB FEMALE connector  at the computer
Pin Name Dir Description
1 /STROBE --> Strobe
2 D0 <-> Data Bit 0
3 D1 <-> Data Bit 1
4 D2 <-> Data Bit 2
5 D3 <-> Data Bit 3
6 D4 <-> Data Bit 4
7 D5 <-> Data Bit 5
8 D6 <-> Data Bit 6
9 D7 <-> Data Bit 7
10 /ACK <-- Acknowledge
11 BUSY <-> Busy
12 POUT <-> Paper Out
13 SEL <-> Select (Shared with RS232 RING-indicator)
14 +5V PULLUP --> +5 Volts DC (10 mA max)
15 n/c - Not connected.
16 /RESET --> Reset
17 GND --- Signal Ground
18 GND --- Signal Ground
19 GND --- Signal Ground
20 GND --- Signal Ground
21 GND --- Signal Ground
22 GND --- Signal Ground
23 GND --- Signal Ground
24 GND --- Signal Ground
25 GND --- Signal Ground

Note: Direction is Computer relative Peripheral

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts and schemes of parallel ports connectors >  Pinout of Parallel (Amiga) connector and layout of 25 pin D-SUB FEMALE connector

Source(s): Amiga 4000 User"s Guide from Commodore, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
39 hits since February 12, 2005