Pinouts of Connectors

RJ45 Roll-Over cable pinout

layout
schematic diagram

add this page to bookmarks

8 pin RJ45 MALE connector pin-out & layout
8 pin RJ45 MALE connector

You can identify a roll-over cable by comparing the two modular ends of the cable. Holding the cables side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug should be the same color as the wire connected to the pin on the outside of the right plug. If your cable was purchased from Cisco Systems, pin 1 will be white on one connector, and pin 8 will be white on the other.

Conn 1 Conn 2
1 8
2 7
3 6
4 5
5 4
6 3
7 2
8 1

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
8 pin RJ45 MALE connector pin-outs & layouts
8 pin RJ45 MALE connector
Pinouts.ru > Pinouts and schemes of serial ports cables >  Pinout of RJ45 Roll-Over cable and layout of 8 pin RJ45 MALE connector and 8 pin RJ45 MALE connector

Source(s): Cisco Systems, Inc. and Technick.net
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
197 hits since February 11, 2005