Pinouts of Connectors

SCSI Internal (2.5 inch) pinout

layout
schematic diagram

add this page to bookmarks

40 pin IDC MALE connector pin-out & layout
40 pin IDC MALE connector  at the controller & peripherals (0.75
Pin Name Dir Description
1 +5V --- +5 VDC
1 +5V --- +5 VDC
1 RET --- Return (Ground?)
1 RET --- Return (Ground?)
1 GND <-> Ground
2 DB0 <-> Data Bus 0
1 GND <-> Ground
4 DB1 <-> Data Bus 1
1 GND <-> Ground
6 DB2 <-> Data Bus 2
1 GND <-> Ground
8 DB3 <-> Data Bus 3
1 GND <-> Ground
10 DB4 <-> Data Bus 4
1 GND <-> Ground
12 DB5 <-> Data Bus 5
1 GND <-> Ground
14 DB6 <-> Data Bus 6
1 GND <-> Ground
16 DB7 <-> Data Bus 7
1 GND <-> Ground
18 PARITY <-> Data Parity (odd Parity)
24 GND --- Ground
26 TMPWR <-> Termination Power
32 /ATN <-- Attention
36 /BSY <-> Busy
24 GND --- Ground
38 /ACK <-- Acknowledge
40 /RST <-> Reset
42 /MSG --> Message
24 GND --- Ground
44 /SEL <-> Select
50 /I/O --> Input/Output
46 /C/D --> Control/Data
24 GND --- Ground
48 /REQ --> Request
1 RET --- Return (Ground?)
1 RET --- Return (Ground?)
1 +5V --- +5 VDC
1 +5V --- +5 VDC

Note: Direction is Device relative Bus (other Devices). Connector is: AMP 6-176135.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
40 pin IDC FEMALE connector pin-outs & layouts
40 pin IDC FEMALE connector  at the cable (0.75
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of SCSI Internal (2.5 inch) and layout of 40 pin IDC MALE connector and 40 pin IDC FEMALE connector

Source(s): Electrical Interface Spec for IBM DPRS-20810 and DPRS-21215 at IBM Hard disk drive support
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
66 hits since February 12, 2005