Pinouts of Connectors

Apple SCSI disk adapter connector pinout

layout
schematic diagram

add this page to bookmarks

These connectors are found on the SCSI Disk Adapter cable

30 pin Apple HDI-30 connector pin-out & layout
30 pin Apple HDI-30 connector  at the Apple computer, looking into cable-side connector
Pin Name Dir Description
1 n/c   Reserved for SCSI disk mode.
2 /DB0 <-> Bit 0 of SCSI data bus
3 GND --- Ground
4 /DB1 <-> Bit 1 of SCSI data bus
5 TPWR <-> Termination power
6 /DB2 <-> Bit 2 of SCSI data bus
7 /DB3 <-> Bit 3 of SCSI data bus
8 GND --- Ground
9 /ACKS <-- Handshake signal. When low acknowledges a request for data transfer
10 GND --- Ground
11 /DB4 <-> Bit 4 of SCSI data bus
12 GND --- Ground
13 GND --- Ground
14 /DB5 <-> Bit 5 of SCSI data bus
15 GND --- Ground
16 /DB6 <-> Bit 6 of SCSI data bus
17 GND --- Ground
18 /DB7 <-> Bit 7 of SCSI data bus
19 /DBP <-> SCSI data bus parity bit
20 GND --- Ground
21 /REQ --> Request for a data transfer
22 GND --- Ground
23 /BSY <-> When active (low) indicates that the SCSI data bus is busy
24 GND --- Ground
25 /ATN <-- When active (low) indicates an attention condition
26 /C/D --> When active (low) indicates that data is on the SCSI bus. When high, indicates that control signals are on the bus
27 /RST <-> SCSI bus reset
28 /MSG --> Indicates the message phase
29 /SEL <-> SCSI select
30 /I/O --> Controls the direction of data output. When high, data is input

Note: Direction is Device relative Bus (other Devices)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of Apple SCSI disk adapter connector and layout of 30 pin Apple HDI-30 connector

Source(s): Apple Tech Info Library 12929: Duo Dock/Duo Dock II, External Pinouts at Apple TIL homepage, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
48 hits since February 12, 2005