Pinouts of Connectors

SCSI-III External Hi D-Sub (Single-ended) connector pinout

layout
schematic diagram

add this page to bookmarks

68 pin HI-DENSITY D-SUB FEMALE connector pin-out & layout
68 pin HI-DENSITY D-SUB FEMALE connector  at the controller & devices
Pin Name Dir Description
1-16 GND --- Ground
17 TERMPWR <-> Termination Power
18 TERMPWR <-> Termination Power
19 res <-> reserved
20-34 GND --- Ground
35 DB12 <-> Data Bus 12
36 DB13 <-> Data Bus 13
37 DB14 <-> Data Bus 14
38 DB15 <-> Data Bus 15
39 DPB1 <-> Data Parity (odd Parity)
40 DB0 <-> Data Bus 0
41 DB1 <-> Data Bus 1
42 DB2 <-> Data Bus 2
43 DB3 <-> Data Bus 3
44 DB4 <-> Data Bus 4
45 DB5 <-> Data Bus 5
46 DB6 <-> Data Bus 6
47 DB7 <-> Data Bus 7
48 DPB <-> Data Parity (odd Parity)
49 GND --- Ground
50 GND --- Ground
51 TERMPWR <-> Termination Power
52 TERMPWR <-> Termination Power
53 res --- reserved
54 GND --- Ground
55 /ATN <-- Attention
56 GND --- Ground
57 /BSY <-> Busy
58 /ACK <-- Acknowledge
59 /RST <-> Reset
60 /MSG --> Message
61 /SEL <-> Select
62 /C/D --> Control/Data
63 /REQ --> Request
64 /I/O --> Input/Output
65 DB8 <-> Data Bus 8
66 DB9 <-> Data Bus 9
67 DB10 <-> Data Bus 10
68 DB11 <-> Data Bus 11

Note: Direction is Device relative Bus (other Devices)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
68 pin MALE connector pin-outs & layouts
68 pin MALE connector  at the cable
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of SCSI-III External Hi D-Sub (Single-ended) connector and layout of 68 pin HI-DENSITY D-SUB FEMALE connector and 68 pin MALE connector

Source(s): SCSI FAQSCSI 68 Pin Normal pinout at The Pin-Out directory, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
62 hits since February 12, 2005