pinouts

SCSI-III External Hi D-Sub (Single-ended) connector

pinout (распиновка)

запомнить адрес в закладки

SCA=Single connector Attachment

разъем 80 pin SCSI SCA-2 female
80 pin SCSI SCA-2 female connector

Drive connector: AMP Champ 557613-1 or AMP Champ 557114-5
Cable connector: AMP Champ 2-557103-1 or AMP Champ 2-557101-1

Pin Name Dir Description
1 12V --- +12 VDC
2 12V --- +12 VDC
3 12V --- +12 VDC
4 12V --- +12 VDC
5 3.3V --- +3.3 VDC
6 3.3V --- +3.3 VDC
7 -DB(11) <-> Data Bus 11
8 -DB(10) <-> Data Bus 10
9 -DB(9) <-> Data Bus 9
10 -DB(8) <-> Data Bus 8
11 -I/O --> Input/Output
12 -REQ --> Request
13 -C/D --> Control/Data
14 -SEL <-> Select
15 -MSG --> Message
16 -RST <-> Reset
17 -ACK <-- Acknowledge
18 -BSY <-> Busy
19 -ATN <-- Attention
20 -P_CRCA ?  
21 -DB(7) <-> Data Bus 7
22 -DB(6) <-> Data Bus 6
23 -DB(5) <-> Data Bus 5
24 -DB(4) <-> Data Bus 4
25 -DB(3) <-> Data Bus 3
26 -DB(2) <-> Data Bus 2
27 -DB(1) <-> Data Bus 1
28 -DB(0) <-> Data Bus 0
29 -DB(P1) ?  
30 -DB(15) <-> Data Bus 15
31 -DB(14) <-> Data Bus 14
32 -DB(13) <-> Data Bus 13
33 -DB(12) <-> Data Bus 12
34 5V --- Ground (Signal)
35 5V --- Ground (Signal)
36 5V CHARGE --- Ground (Signal)
37 SPINDLE SYNC ? Spindle Sync
38 RMT_START ? Remote Start
39 SCSI ID (0) --- SCSI ID Bit 0
40 SCSI ID (2) --- SCSI ID Bit 2
41 12V GROUND --- +12 VDC Ground
42 12V GROUND --- +12 VDC Ground
43 12V GROUND --- +12 VDC Ground
44 MATED 1 ?  
45 3.3V CHARGE --- +3.3 VDC Charge
46 GROUND --- Ground
47 SIGNAL RETURN --- Ground (Signal)
48 SIGNAL RETURN --- Ground (Signal)
49 SIGNAL RETURN --- Ground (Signal)
50 SIGNAL RETURN --- Ground (Signal)
51 SIGNAL RETURN --- Ground (Signal)
52 SIGNAL RETURN --- Ground (Signal)
53 SIGNAL RETURN --- Ground (Signal)
54 SIGNAL RETURN --- Ground (Signal)
55 SIGNAL RETURN --- Ground (Signal)
56 SIGNAL RETURN --- Ground (Signal)
57 SIGNAL RETURN --- Ground (Signal)
58 SIGNAL RETURN --- Ground (Signal)
59 SIGNAL RETURN --- Ground (Signal)
60 SIGNAL RETURN --- Ground (Signal)
61 SIGNAL RETURN --- Ground (Signal)
62 SIGNAL RETURN --- Ground (Signal)
63 SIGNAL RETURN --- Ground (Signal)
64 SIGNAL RETURN --- Ground (Signal)
65 SIGNAL RETURN --- Ground (Signal)
66 SIGNAL RETURN --- Ground (Signal)
67 SIGNAL RETURN --- Ground (Signal)
68 SIGNAL RETURN --- Ground (Signal)
69 SIGNAL RETURN --- Ground (Signal)
70 SIGNAL RETURN --- Ground (Signal)
71 SIGNAL RETURN --- Ground (Signal)
72 SIGNAL RETURN --- Ground (Signal)
73 SIGNAL RETURN --- Ground (Signal)
74 MATED 2 ?  
75 5V GROUND --- +5 VDC Ground
76 5V GROUND --- +5 VDC Ground
77 ACTIVE LED OUT ?  
78 DLYD_START ?  
79 SCSI ID (1) --- SCSI ID Bit 1
80 SCSI ID (3) --- SCSI ID Bit 3

5: RESERVED/NC 6: RESERVED/NC 20: -DB(P0) 36: 5 VOLT 44: 12 V GROUND 45: RESERVED/NC 46: RESERVED/NC 74: 5 V GROUND

Note: Direction is Device relative Bus (other Devices)

Эта информация должна быть правильной, но ошибки вполне возможны. Вы можете помочь!
Вы можете подтвердить правильность документа (только если действительно уверены), или сообщить об ошибке в документе (ошибка может быть описана далее по ссылке). Ваше мнение будет учтено при расчете статуса документа.
Pinouts.ru > Разъемы для подключения винчестеров >  Распиновка SCSI-III External Hi D-Sub (Single-ended) connector использующего разъем 80 pin SCSI SCA-2 female

Источник(и): SCA SFF-8015 Draft Rev 3.1, from Hardware Book
Статус документа: не подтвержденный
отметить как ошибочный!
отметить как правильный		 0 отзыв(ов)
Щелкните по одной из ссылок для изменения статуса документа.
[Обсудить на форуме] [Назад к оглавлению] [Добавить распайку]
[Сообщить об ошибке или обновлении]
Maintained by pinouts.ru team
This information is provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application
50 hits since February 12, 2005