Pinouts of Connectors

Nintendo NES and SNES Controller Connector pinout

layout
schematic diagram

add this page to bookmarks

7 pin SNES SPECIAL female connector pin-out & layout
7 pin SNES SPECIAL female connector  at the Console
Pin Description Wire Color
1 +5v White
2 Data Clock Yellow
3 Data Latch Orange
4 Serial Data Red
5 N/C -
6 N/C -
7 Ground Brown

The SNES pad works exactly the same as the NES controller, except it has two 4021"s inside, and there are sixteen pulses on the CLK line, and sixteen bits of data come out the Data line.As a matter of fact, a SNES pad can be connected to a NES by simply swapping the connector on the end.

Clock pulse and corresponding button

  1. B
  2. Y
  3. Select
  4. Start
  5. North
  6. South
  7. West
  8. East
  9. A
  10. X
  11. L
  12. R
  13. [no button, always high]
  14. [no button, always high]
  15. [no button, always high]
  16. [no button, always high]

NES controller


       o 4

  1 o  o 5

  2 o  o 6

  3 o  o 7

    

  1. +5VDC Supply
  2. ?
  3. ?
  4. GND
  5. CLK
  6. Latch
  7. Data out

The NES starts the show by sending a high pulse down the Latch line, which makes the 4021 (8-bit shift register) inside the controller grab and store the state of all buttons.

Then the NES sends a series of eight low pulses down the CLK line, which makes the controller shuffle bits (one for each CLK pulse) down the Data Out line according to which buttons were pressed when latched. A low bit on the Data Out line means the button is pressed.

Clock pulse and corresponding button

  1. A
  2. B
  3. Select
  4. Start
  5. North
  6. South
  7. West
  8. East

Pins 2 & 3 aren"t used on the standard pad. I believe they may be used with alternative controllers like the light gun or Arkanoid paddle.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of videogames connectors >  Pinout of Nintendo NES and SNES Controller Connector and layout of 7 pin SNES SPECIAL female connector

Source(s): SNES / Super Famicom Joystick Data at GamesX
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
124 hits since February 11, 2005