Pinouts of Connectors

SONY 14 pin connector pinout

layout
schematic diagram

add this page to bookmarks

for some old cameras like SONY HVC3000C

14 pin SONY BETAMAX female connector pin-out & layout
14 pin SONY BETAMAX female connector
Pin Signal
1 Camera video out
2 Camera video out ground
3 Camera video in
4 Camera video in ground
5 Camera pause. Shorting this pin momentarily to ground will toggle between pause and record or play mode.
6 Tally signal from the video to the camera. This causes the red light in the view finder to be displayed on the camera. It puts 5v on the pin when the video is in Record Mode, Playback, Audio Dub, x2 or Cue/Review mode.
7 Camera audio out CH-2
8 Record review. When the record review switch is pressed on the camera the video plays the last three seconds of the previous recording for monitoring.
9 Camera audio out CH-1
10 Audio ground
11 Camera audio in CH-1
12 Camera audio in CH-2
13 Camera power 12v in. Note, this is internally fused in the VCR
14 Power ground

Note: Not all machines implement all available options.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
14 pin SONY BETAMAX male connector pin-outs & layouts
14 pin SONY BETAMAX male connector
Pinouts.ru > Pinouts of some home Audio/Video stuff. >  Pinout of SONY 14 pin connector and layout of 14 pin SONY BETAMAX female connector and 14 pin SONY BETAMAX male connector

Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
85 hits since February 11, 2005