Pinouts of Connectors

SONY LANC interface pinout

layout
schematic diagram

add this page to bookmarks

available at the modern SONY camcorders

3 pin stereo jack MALE connector pin-out & layout
3 pin stereo jack MALE connector  at the cable (2.5 mm jack used)
LANC™ is a bidirectional serial open collector communication interface. The camcorder gets its commands and sends back counter, status and other data. Service mode is accessible.

2.5 mm jack or 5 pin mini-din connectors may be used:

Pin of
jack / minidin
Signal Description
ground / 5Ground  
R / 1+Vdc +5...8 volt, depending on model and battery used
L / 4LANC  
3Switch Connect Pin 3 to GND for >140 ms to power on/off
2CTL  

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
5 pin mini-din connector pin-outs & layouts
5 pin mini-din connector
Pinouts.ru > Pinouts of some home Audio/Video stuff. >  Pinout of SONY LANC interface and layout of 3 pin stereo jack MALE connector and 5 pin mini-din connector

Source(s): LANC insight
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
105 hits since February 12, 2005