Pinouts of Connectors

Ethernet 10/100Base-T Crossover cable pinout

layout
schematic diagram

add this page to bookmarks

This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX

8 pin RJ45 MALE connector pin-out & layout
8 pin RJ45 MALE connector  to the network interface card 1
Name NIC1 NIC2 Name
TX+ 1 3 RX+
TX- 2 6 RX-
RX+ 3 1 TX+
RX- 6 2 TX-

Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair. (Just as the table above shows). Note 2: You could also connect 4-4, 5-5, 7-7, 8-8.

8 pin RJ45 MALE connector pin-outs & layouts
8 pin RJ45 MALE connector  to the network interface card 2
Pinouts.ru > Pinouts and schemes of cables for local networks >  Pinout of Ethernet 10/100Base-T Crossover cable and layout of 8 pin RJ45 MALE connector and 8 pin RJ45 MALE connector

Source(s): Hardware Book, Jason D. Pero , Oscar Fernandez Sierra, Jeffrey R. Broido, Patrick Smart
Document status: correct
mark as erroneous!
mark as correct
2 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
151 hits since February 11, 2005