pinouts

USB internal motheboard connector

pinout (распиновка)

запомнить адрес в закладки

used for card-edge bracket additinal USB ports

разъем 10 pin IDC male
10 pin IDC male connector  at the motheboard (may be varied)
Pin Signal Description
1Vcc +5V for USB port 1
3Data0- for USB port 1
5Data0+ for USB port 1
7GND for USB port 1
9keyed  
2Vcc +5V for USB port 2
4Data1- for USB port 2
6Data1+ for USB port 2
8GND for USB port 2
10N/Cfor USB port 2
This is a sample pinout from Epox motherboard manual. IT"S may be DIFFERENT for other motherboards.
Before connecting any external bracket you should check them and replug wires according to your motherboard manual USB pinout (if needed).
If you have no access to the motheboard manual, you can try determine pinout manually.
USE AT YOU OWN RISK! May be dangerous for your equipment!
You can easily determine position of +5V and GND with multimeter. After this, plug the bracket with this pins set correctly and try to connect some device. If your device working - fine you"ve done it. If not - try to exchange Data- and Data+ wires and try again.

Ссылки по теме:
Pinouts.ru > Разные коннекторы на материнской плате >  Распиновка USB internal motheboard connector использующего разъем 10 pin IDC male

Статус документа: подтвержденный
отметить как ошибочный!
отметить как правильный
1 отзыв(ов)
Щелкните по одной из ссылок для изменения статуса документа.
[Обсудить на форуме] [Назад к оглавлению] [Добавить распайку]
[Сообщить об ошибке или обновлении]
Maintained by pinouts.ru team
This information is provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application
153 hits since February 12, 2005